Changes between Version 8 and Version 9 of Doc/Models/LMDZ

Timestamp:

10/23/14 10:13:21 (10 years ago)

Author:

jgipsl

Comment:

--

Doc/Models/LMDZ

@@ -31 +31 @@
 vertical grids of LMDZ.
 
-You can find a documentation on climoz file use for IPCC [https://forge.ipsl.jussieu.fr/igcmg/wiki/InfosOzone here]
+You can find a documentation on climoz file use for IPCC [https://forge.ipsl.jussieu.fr/igcmg/wiki/InfosOzone here at the igcmg wiki]
 
 
@@ -39 +39 @@
 ## Creating initial states and interpolating boundary conditions ## 
 
-Once you chose and installed your configuration, you will find the config.card and lmdz.card files in the modipsl/config/.../EXPERIMENTS/LMDZ/CREATE_''xxx'' directories. These files allow you to prepare jobs that create restarts and boundary conditions from initial files located on shared accounts. The jobs follow the classical procedure explained [wiki:/DocEsetup here]. The files found in the directories are:
+Once you chose and installed your configuration, you will find the config.card and lmdz.card files in the modipsl/config/.../EXPERIMENTS/LMDZ/CREATE_''xxx'' directories. These files allow you to prepare jobs that create restarts and boundary conditions from initial files located on shared accounts. The jobs follow the classical procedure explained in [wiki:/DocEsetup Chapter 3: Simulation setup]. The files found in the directories are:
 
  CREATE_clim::
@@ -105 +105 @@
 
 ## Files already created with the IPSL coupled model outputs ##
-[wiki:BoundaryFiles]
-
+Some coupled simulations have already been used as boundary conditions for simulations in forced mode. Read more on the igcmg wiki about these files and where to find them: 
+[https://forge.ipsl.jussieu.fr/igcmg/wiki/BoundaryFiles]
 
 ## Using restart files of a IPSLCM5 coupled simulation to start a forced simulation ##